The D.L.
Ricci Corp. Portable Boring Bars are available in two different
configurations, either "Push Pull" or "Feed Screw".
The push-pull boring bar design is available for all D.L. Ricci
Corp. boring systems while four inch diameter and larger boring
bars, accommodate the feed screw design. Both these boring bar
configurations can be setup for line boring, blind boring and
facing operations.
Our modular design allows the drive unit and alignment mounts
to attach anyplace along the portable boring bar, enhancing
setup capabilities in even the most difficult of setup situations.
The rotational unit of the Portable Boring Bar is compact, with
high power to weight performance. Powerful hydraulic or pneumatic
motors, coupled with our heavy duty gear box, provide smooth
and trouble free cutting.
The mounting systems may consist of the two adjustable bearing
end plates, or a combination of a bearing end plate and the
ID mount spider system. The bearing end plates are designed
to adjust in any direction and miter to compensate for any misalignment.
Roller bearings are used in all setup fixtures to assure smooth,
accurate cutting performance. The power feed unit for both types
of bars ("Push-Pull" or "Feed Screw") is
a reversible, variable feed rate servo drive.
After the page loads choose
which version you'd like to watch based on your connection
speed - High Speed (DSL, Cable Modem) or Low Speed(Dial
Up 56K Modem). Don't worry if you don't choose the right
one at the start you can adjust if the movie is taking
too long to load. Click on the H or L button to change
the movies settings once it has loaded. Use the buttons
below the video from right to left Play/Pause, Rewind
and Play.
View more videos by visiting the video section of the
site here.
* DIMENSION
SUBJECT TO CHANGE WITH DIFFERENT TOOLING CONTACT YOUR
SALES CONSULTANT FOR SPECIFICS.
You
may also need these accessories: Tool
Bits Facing
Attachments In-Line
Couplers Bore
Welder Adapter Plates Drive
Motors Spider
Supports Mounting
Adapters
