The new MS-JTL combines
our patented Midsize (MS) Clamshell and journal turning lathe
(JTL), for a precision machining tool that turns large diameter
shafts accurately. Designed for larger diameter shaft refurbishment
(8" to 26"), the MS-JTL has two feed screws for parallel
motion. This results in smoother journal turning and more accuracy.
Ease of setup is realized with the lightweight design and fully
adjustable locators of this shaft refurbishment machine. The
unique split frame design of the MS-Journal Turning Lathe allows
it to clamp over the existing shaft enhancing setup options.
The MS-JTL can be positioned in tight onsite machining areas
that need precision machining with minimal operating clearance
required.
A two-speed gearbox driven by an electric servo allows for fast
setup and smooth surface finishes. Accurate cutting tolerances
and exacting surface finishes are achieved through the rigid
bearing system and rugged design of this precision machining
system.
This hybrid portable lathe machine may be powered by Hydraulic,
Pneumatic or Electric power and comes complete in a box with
everything you’ll need to turn shafts for almost any OD
turning application.
After the page loads choose
which version you'd like to watch based on your connection
speed - High Speed (DSL, Cable Modem) or Low Speed(Dial
Up 56K Modem). Don't worry if you don't choose the right
one at the start you can adjust if the movie is taking
too long to load. Click on the H or L button to change
the movies settings once it has loaded. Use the buttons
below the video from right to left Play/Pause, Rewind
and Play.
View more videos by visiting the video section of the
site here.
