The FX3.0 Micro from
High Purity Piping Technology (HPPT) is a lightweight tool suitable
for hand held or bench mounted tube-squaring and bar chamfering
operations on tubes from .187" OD to 3.0" OD. With
its innovative rapid collet locking system, fitting and tubing
are quickly and accurately held into position during the prepping
operation. The interchangeable collets allow short grip length
for machining all types of micro fittings.
Easy set-up and safe operation of this tube squaring tool is
accomplished with minimal operator training.
The FX3.0 Micro features a high torque, variable speed electric
drive that delivers safe and reliable operation. Variable RPM
output allows the operator the flexibility to accurately machine
all types of exotic material and configurations without damage
to their surface, providing a smooth burr free end preparation.
Cordless operation of this hand held chamfering tool is another
convenience with the FX3.0 Micro.
The micrometer feed system allows smooth, controlled and constant
feed rates. This helps to minimize chatter and gives the operator
greater control, reducing scrap and minimizing job cost overruns.
Accurate, burr free weld preparation is achieved with minimal
effort. Nothing out performs or out lasts our FX3.0 Micro tube
squaring machine.
After the page loads choose
which version you'd like to watch based on your connection
speed - High Speed (DSL, Cable Modem) or Low Speed(Dial
Up 56K Modem). Don't worry if you don't choose the right
one at the start you can adjust if the movie is taking
too long to load. Click on the H or L button to change
the movies settings once it has loaded. Use the buttons
below the video from right to left Play/Pause, Rewind
and Play.
View more videos by visiting the video section of the
site here.
Bits
